Open Port - NAT Port (EN)

Open port (NAT Port) Mi Router 4C, 4A, AX1800, AX6000, 4 Pro, AC1200, AC2100

Posted on by CCTVAPP.NET
13
Sep

Today I will show you how to open the modem port to install install remote camera view. Opening the port for the camera and using the domain name will help connect to the camera faster when using Cloud P2P. Also in case of remote pull also need to open the port. This guide is applicable to the following Xiaomi models:

4C, 4A, AX1800, AX6000, 4 Pro, AC1200, AC2100, …

No matter what modem port you open, regardless of carrier. You need to prepare yourself some of the following requirements:

  • Identifies the IP address of the DVR and the ports to open. 
  • Identifies the IP address of the modem (on cmd -> type ipconfig -> see address of Gateway)
  • Computer or phone and camera receiver must be connected modem’s internet connection.

Step 1: Login to Xiaomi Router

  • Log in to your modem by opening a web browser and typing: http://192.168.1.1 (default). It will appear the modem’s interface and ask to log in.
  • The default account and password for this modem is usually listed on the stamp below the modem. The default is:  admin/admin
  • Normal  then you can log in right away, the password is wrong because it has been changed. Contact the operator’s HTKT switchboard for support.

Step 2: Open port on RouterXiaomi

After logging in to the modem, select Advanced -> Port forwarding -> Port forwarding rules -> Add rule and enter the following information:

  • Name: Enter a rule name (anything is fine).
  • Protocol: Select TCP for Camera, DVR, XVR.< /li>
  • Internal Port: The internal port of the device that needs outbound NAT. This example is port: 80
  • External Port: The external port needs to be open for the signal to come in. This example is port: 80
  • Internal IP: IP address of the device that wants to open the port.

After entering information is complete, press Add to get the interface as above. As above, you are opening port 80 for device with ip address: 192.168.1.99

Step 3: Check port opening

After opening the port. You need to check if your port is open or not.

  • Browser will redirect to another page here you do the following: 
  • Click on the number after the text Your IP is
  • In the box IP address or host name  will appear that sequence of numbers
  • In the box Port Number you enter the ports you have opened. press Go.
  • If the results are as shown above, you are successful. In contrast, as shown in the image below, you are not successful, need to recheck the steps performed in on. 

Good luck with the installation!