Site icon CCTV Application System

Open port (NAT Port) modem VNPT iGate GW040-H, GW020-H

Today I will show you how to open the modem port to install install remote camera view. Opening the port for the camera and using the domain name will help connect to the camera faster when using Cloud P2P. Also in case of remote pull also need to open the port. This guide is applicable to the following models of VNPT:

GW040-H, GW020-H, …

No matter what modem port you open, regardless of carrier. You need to prepare yourself some of the following requirements:

Step 1: Login to VNPT modem

Continue to press “Advanced”, the browser will look like the image below:


Press “Continue to 192.168.1.1 (unsecure)” to go to the login page.

Step 2: Open port on VNPT Modem

After logging into the modem, select Advanced Setup -> NAT -> Virtual Servers and fill in the following information:

As the picture shows, I’m opening port: 34567for the device with the ip address: 192.168.1.253


Step 3: Check port opening results

After opening the port. You need to check if your port is open or not.

Good luck with the installation!

Exit mobile version